eNet radio dimming actuator 4-gang, for rail mounting

Rail mounting device, 8 rail units.

Intended use

• Switching and dimming of incandescent lamps, HV halogen lamps, dimmable HV-LED lamps, dimmable compact fluorescent lamps, dimmable inductive transformers with LV halogen or LV LED lamps, dimmable electronic transformers with LV halogen or LV LED lamps
• Operation with power supply (ref.-no. NT 1220 REG VDC) and receiver module (ref.-no. FM FK 32 REG) or eNet server
• Operation with suitable eNet radio transmitters
• Installation in distribution boxes on DIN rail according to DIN EN 60715

Product characteristics

• Switch-on via bulb-preserving soft start
• Switch-on brightness for each output can be saved permanently
• Minimum brightness for each output can be saved permanently
• Scene operation possible
• Status indication of the outputs via LED
• Status feedback to radio transmitter
• Outputs switchable with Prog button
• Increase in output power possible through parallel switching of multiple outputs
• Electronic short-circuit protection with permanent switch-off after 7 seconds at the latest
• Electronic over-temperature protection
• Automatic or manual setting of the dimming principle suitable for the load
• Power extension possible by means of power boosters. Do not connect any HV-LED lamps or compact fluorescent lamps in combination with power boosters

Can be set with eNet server

• Maximum brightness
• Dimming speed
• Switch-on delay / switch-off delay
• Dim up/dim down ramp
• Switch-off warning
• Operation locks
• Continuous on, Continuous off
• Hotel function
• Run-on time
• Light control

Supplementary functions with eNet server

• Update of the device software
• Reading of error memory