eNet radio switch/push-button actuator 8-gang / blinds actuator 4-gang, for rail mounting

Rail mounting device, 4 rail units.

Intended use

• Switching of lighting
• Switching of single-phase fan motors
• Controlling electrically driven blinds, shutters and awnings
• Operation with suitable eNet radio transmitters
• Operation with power supply (ref.-no. NT 1220 REG VDC) and receiver module (ref.-no. FM FK 32 REG) or eNet server
• Installation in distribution boxes on DIN rail according to DIN EN 60715

Product characteristics

• Operating mode switch for switch-over of switch actuator, push-button actuator, blind actuator, shutter actuator or configuration via eNet server
• Status feedback to radio transmitter
• Scene operation possible
• Outputs switchable with Prog button
• Status indication of the outputs via LED

Switching operation:

• Switch-on telegram: Device switches on
• Switch-off telegram: Device switches off

Push-button operation

• Relay contact remains closed as long as ON or OFF telegrams are being received
• The maximum switch-on time is 60 seconds

Operating mode "Venetian blind/Rolling shutter"

• Positioning of the blind and slats via scene recall
• Position for sun protection and twilight can be saved
• Blind/shutter running time can be saved
• Slat change-over time can be saved
• Fabric-stretching for awnings

Can be set with eNet server in switching/push-button operation

• Operating mode for each output can be set separately
• Flash function
• Run-on time
• Switch-on delay / switch-off delay
• Operation as NO or NC contacts
• Switch-off warning
• Minimum switching repeat time
• Operation locks
• Continuous on, Continuous off

Can be set in the operating mode "Venetian blind/Rolling shutter" with eNet server

• Change-over time for direction change
• Running direction invertible
• Position for sun protection, twilight, lock-out protection and wind alarm

Supplementary functions with eNet server

• Update of the device software
• Reading of error memory