System information
This device is a product of KNX system and corresponds
to the KNX guidelines. Detailed specialised
knowledge obtained from KNX training courses
is required for comprehension. The planning,
installation and commissioning of the device is
carried out with the help of KNX-certified software.
Systemlink commissioning
The function of the device is software-dependent.
The software is to be taken from the product
database. You can find the latest version of the
product database, technical descriptions as well as
conversion and additional support programmes on
our website.
Easylink commissioning
The function of the device is configuration-dependent.
The configuration can also be done using
devices developed specially for simple setting and
start-up.
This type of configuration is only possible with
devices of the easylink system. Easylink stands for
easy, visually supported start-up. Preconfigured
standard functions are assigned to the in/outputs
by means of a service module.
Functional description
The device has three load outputs that can be
combined variably using a slide switch to increase
loads. It works with automatic load detection
depending on the connected load in the phase
cut-on or phase cut-off and enables switching and
dimming via the KNX bus of:
-
incandescent lamps and halogen lamps.
-
Low-voltage halogen lamps with conventional
or electronic transformer.
-
Dimmable LED and energy-saving lamps.
Additionally, the device has a learn function for
more efficient control of energy-saving lamps and
230 V LED lamps.
Correct use
-
Dimming of electric consumers AC 230 V.
-
Installation on DIN rail according to
DIN EN 60715 in distribution box
Product characteristics
-
Status display of the outputs on the device.
-
Manual activation of the outputs on the device
is possible, building site operation.
-
Automatic load detection.
-
Setting the minimum and maximum dimming
value.
-
Timer functions.
-
Scene function.
-
Forced position by higher-level controller.
Short-circuit and overload protection
Short-circuit and overload are signalled via the
control LED. The load is throttled.
Overheating protection
Overheating of the device is signalled by a permanent
light of the control LED. The connected
load is throttled.